- D31-41-650 was used for WR250X.As a result, it is not possible to pimp the OEM Exhaust System.All the inner diameter outer diameter all the lengths are no good, it was torn when I put it in the OEMMan...Прочитайте больше
- It is an essential Items when replacing Silencer,When newly fitting the exhaust pipe, install it on the exhaust pipe side rather than putting it in the silencer side.I think it would be smoother to pu...Прочитайте больше
- I bought this product because my XR250MOTARD was leaking gas from the joint gasket and it was bothering my neighbors. the KITACO product was cheaper, but I wanted to stop the leaking completely and it...Прочитайте больше
- Thank you, WEBIKE! I didn't think I would ever find the right part. This exhaust joint gasket fits the Delta Barrel 4 Exhaust. I didn't have a caliper to measure the exact fit of the exhaust joint and...Прочитайте больше
- I bought it again because it was new and somehow it got into the back of the MiddlePipe.I've bought JMCA Certified for places where I can't run without changing the exhaust system many times, but the ...Прочитайте больше
- I installed it in the OEM joint of KLX250SRThe outer diameter was Exactly, but the inner diameter was too big and there was no space between the clamps no matter how much you tighten the clamps It fel...Прочитайте больше
- I bought it for when I removed and adjusted the Exhaust System in spring and adjusted it afterwards.The product will be purchased for the third time.There are BALI on the cut surface, but it is accept...Прочитайте больше
- We did this because we did not deal with Yamaha OEM Product with Webike, but it does not enter Exhaust at all for wr 250 x. I forcibly cut it with File and forcibly put it in. I will never buy this pr...Прочитайте больше
- You can use it without any problem.It is recommended.I think that it is convenient because it can buy it with Net.If you are worried I think that OEM can also be bought here.Прочитайте больше
- It is a Gasket of the connection section of a Silencer and an Exhaust pipe. If it reuses here, omission in exhaust steam of most will be carried out.It is mere a few.It reused, although a loud sound d...Прочитайте больше
- purchasing last time at the time of Muffler exchange -- necessity -- since it was enough, it re-purchased this time to compensate for EX pipe replacement.A function is satisfactory and good to be able...Прочитайте больше
- It chose by the ease of carrying out of acquisition.Even if it compares that it is pure, there is no difference of appearance, and the engine performance as a Gasket and a function are enough.Although...Прочитайте больше
- Simultaneous purchase was carried out with the Barrel 4s Muffler.Since he would like to also change the Exhaust pipe, it purchases, and I think that it was good.
Прочитайте больше - although it had clung by 1st Pipe purchase by Silencer purchase in the form which became brave although it was the 2nd time so that 2 time did not have the necessity for purchase -- -- it is relief s...Прочитайте больше
- It was used when attaching Barrel 4 of DELTA to a SEROW250.
Since in the case of the SEROW a Gasket is attached to a Normal silencer and it Says, this is removed and reuse is difficult.
It is easi...Прочитайте больше - I thought that I would exchange the muffler itself and ordered the gasket. Since it is troublesome if it is after there is exhaust leakage although I think that it is not necessary to exchange, I chan...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА