- I saw it on impressions and bought it.It's better to have it attached, isn't it?I just need to install it. Is it an individual difference?Mine was really tight.I was lucky to get one of them in, but t...Прочитайте больше
- The end cap that came with No Brand's Rear Sets flew away, so I immediately bought the OverRACING cap when I saw it. The product is well made and a good product.Of course, the Body is not OverRACING, ...Прочитайте больше
- Installed on OVER Rear Sets without end caps.It gives a very good sense of unity.Прочитайте больше
- I wish it came with me from the beginning….Without it, it looks cheap….Прочитайте больше
- I put it on the Tandem Footpeg Slider from Over.Although I was prepared for this because I had heard from other impresarios that it was not easy to get into the hole.It is not very straightforward.I h...Прочитайте больше
- Quantity:I mistakenly thought it was 1 set of 2pcs. and bought another 1pc. after receiving the product.The installation was tight and did not feel like it would go in normally, so I used Router to sh...Прочитайте больше
- To install, remove the footpeg and place the cap underneath and tap the footpeg with a hammer. If you leave the footpeg on the car, it will not fit. It is installed on the Tandem side. It is a little ...Прочитайте больше
- OVER RACING's Rear Sets.OVER RACING on the endEnd cap installed!Size is a little bit large for Universal.You'll have to scrape and tap a little bit to screw it in.Прочитайте больше
- I installed it on the OVERTandem Footpeg Bar It was installed to OVERRear Sets Bar before, but it was installed to Tandem Footpeg Bar and the Rear Sets bar have the same inner diameter Also, a hang wa...Прочитайте больше
- I used mine as handlebar end caps, and it turned out great. The caps was a tiny bit to narrow for perfect fit inside my handlebar ends, so I made the caps a little bigger with shrink tube. Worked perf...Прочитайте больше
- Even if you hit it with Prague on hand, you can not go in any way. It was useless to soak in hot water and warm it up. I thickened it in the Device, I got a little strange but it floated a little. Lef...Прочитайте больше
- Product photo is Quantity : 2pc. Because it is Set : 1 Set of 2pcs. And I bought it. What is Single Item.And one more pc. Additional purchase ,, shipping cost Waste has been done. To be sorryПрочитайте больше
- It is somewhat thick against the diameter of Step end, so it was pretty rugged so it was hard to install.The last 1 mm does not end up inevitably, but there are gaps, but it is not noticeable and I do...Прочитайте больше
- I installed it at the same time I replaced Rear Sets. Since Footpeg Bar inner diameter and Step bar end cap diameter were made slightly Large, hang was necessary for installation. In order to prevent ...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА