- The standard Frame Slider is installed.It is not as uncomfortable as I expected.BMW is ridiculously overpriced for Cowl, so it's safer to put it on.Прочитайте больше
- I bought the BodyStyle Under Cowl because the KawasakiOEMSlider that I had been wearing for some time would not stick to it after I installed it.I had installed the same manufacturer's Slider on my pr...Прочитайте больше
- It is much cheaper than foreign products, and I am grateful that they make these vehicles even though they are not available in large numbers.You will need Torque, so you may have to spend extra on th...Прочитайте больше
- [How is it used?It has been in use since August 2020.Was the one you received as per Image?PhotoWas the installation difficult?Anyone who can read the instruction manual can do it.How was your experie...Прочитайте больше
- It would be nice to have Line and Mark colors other than a little Black.Прочитайте больше
- It can also be installed on the Z1000 by adding a color.CoolПрочитайте больше
- I bought it in the hope that it would reduce the damage caused by standing moss.It's been about 4 months since I installed it, but so far I haven't had that situation yet, so I don't know how effectiv...Прочитайте больше
- I have not fallen over so I am not sure how effective it is.I hope to remain useless at this.When installing, you will need to bite the Jack to support the Engine.At a minimum, Jack and Rear stand are...Прочитайте больше
- The Slider with a single point of the Frame for Z1000 isDamage is likely to enter the Frame when it falls over.I bought one for my Ninja 1000, which has a 3-point stop that seems to distribute the for...Прочитайте больше
- It's a standard equipmentWhen I looked for a product that can be installed without drilling holes in Cowl, this is what I foundI hope we never have to see the power of this (Bitter smile) 。Прочитайте больше
- After much debate, I decided to install the BABY FACE Frame Slider I had already installed the Axle Slider and I wasn't sure how effective it would be, but I decided to install the BABY FACE Frame Sli...Прочитайте больше
- There was another one that attaches directly to the Frame, but this one is supported by three points I decided to go with this one because I wondered if I could expect Damage to be dispersed at timesI...Прочитайте больше
- Since the Engine Slider is also a Babyface, we'll use the Frame Slider as well choiceI bought this one to avoid scratching the cowl to prevent it from standing upRight Side is likely to guard the Righ...Прочитайте больше
- It's still better to put it on and limit the damage to the Smallest limit before you get sad for nothing without Slider I thought it would be a good idea to get a good deal (let's not mock it before t...Прочитайте больше
- I contacted Babyface and they said that the current MODEL is also OK to install in 2016 Installed on formula Z1000It takes about 10 minutes to installПрочитайте больше
- Installation may be a little confusing The Mount is much different, but that's about itThe shape is a bit obvious I think they looked tighter in the same colorI'm sure there is some reason for this I ...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА