- Used in YSR80.It is not listed in Webig's compatibility, but it is listed in the Manufacturer's compatibility list, so it can be used.Since the Spring was a replacement for a worn-out Spring, I could ...Прочитайте больше
- I installed them on the NSR50 which I bored up to 63cc. The fatigue of the finger increased after running Circuit for half a day.Прочитайте больше
- I exchanged for Maintenance at NS50F.Until then 1. Although there was not dissatisfaction especially at Standard Clutch Spring which used 50,000 km,After exchanging it, I realized that the control per...Прочитайте больше
- When exchanging Friction disks, I also considered and simultaneous-purchase-did degradation of the Clutch spring.By the thing with strengthening, it can use satisfactorily 20% from the pure Spring.I ...Прочитайте больше
- It is quite good, although it is recommended to a friend and a feeling differs from a purchase NORMAL for a while!! Since a Cost performance is also good, it is recommended!!
Прочитайте больше - "Since the genuine spring was coming old, I purchased. The pitch of spring itself is choked up somewhat and longer than a genuine size. It is in a chamber direct carburetor in 50cc of actual condition...Прочитайте больше
- Relation of a clutch became a direct.Прочитайте больше
- Since bore up of the engine was carried out, it strengthened for the sense. Although he thinks that it is OK also with normal,Прочитайте больше
- It purchased in order to carry out bore up and to prevent the slide of a clutch. Although it was a thing that it does not slide to the extent that bore up was carried out to 80 cc, it exchanged just t...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА