Because Hose is hard, I used SiliconHose and the surplus HondaOEM Fuel Hose. Even if the Cook is closed, it does not stop firmly, the fuel that comes out of the taratara. It became a little disappointing.
A must have tools for engine test or engine rebuild . Able to hang on the handle bar .it come with fuel pet cock you can shut off the fuel easily . One of my Tools in my garage View Detail
The TankBody is fine, but the Horses are a lousy product
You want to prevent the Hose Material from tearing due to Gasoline loss Material:Plastic, inflexible and unusable
Cook's Joint also has a different Hose diameter, but it's unclear what the intent was for the carburetor side of the The connection diameter of 5mm inside diameter of Hose is not available for 4 cylinder motorcycles that need to be tuned in Right?
Both the hose and the cook have been modified and improved
View Detail
I bought it to make frequent adjustments to the carburetor, and the Z1's carburetor is Because of the two Fuel Hose, I purchased a three-pronged connecting tube from Home Center Other imprecisions said the included Hose was too long, but this can be solved by cutting it to your personal preference So I don't think it's a problemView Detail
Purchased for the restoration work of the NS 250 R that got out of my house.
Tank rusting, I can not use Tank while I'm coating,
Let's change the Lank while working while shifting Tank.
Confirmation of FUELPump operation, adjustment of carburetor. EG guidance confirmation etc.
It is very easy if there is this.
Since FUELCook is also attached, it does not spill Dabadaba Gasoline when removing Hose
Work efficiency gets better.
It enters 1 LGasoline, but it is a bit uneasy if it is too much, so it is about half
It looks good to use.
However, I think that it would be better to have one, but Hose is long ....
Storage is a little troublesome.View Detail
I used it for Coolant solution exchange of ZrX1200R. Because there is a Radiator cap under Tank, I have to bleed by injecting Coolant solution after engine start but in order to remove Fuel Tank, I purchase items for Maintenance..
Used feeling Make it solid rather than Cost performance Image that can be used for a long time Image included Fuel Cock This can also be used normally without leaking. Although it depends on the car model, since the diameter of Fuel Hose is Universal Product, it is 6 mm and it is 10 mm in the case of ZrX 1200 R so we dealt with Hose Conversion Joint.
It is recommended for Maintenance for Tuning with sufficient performance.View Detail
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА