I tried searching thinking that I wanted to imechen that the original Seat leather was damaged a little, this item came out.
I was hoping that Coloring was a missing item and I made it to Gray × Black that was safe.
Although it is Gray, though it looks at all in the image, it looked only at White, but if the color tone was different from Image, it was a color that could be arrangement with Well-dyed Q and it was good.
Although I forgot to mention, Seat's rework is a complete novice.
The work content is self-current.
By examining with Net
Tucker
needle
Slotted screwdriver
Nipper
Protective glasses
Dryer
It seems to be the minimum necessary tool.
So, I will continue working roughly.
There is no hardship to remove the old Seat leather.
Just pulling out the needle.
Next, set WaterproofSeat on SeatBody.
In the Instruction Manual, it is supposed to stretch leather Seat from above, but I think that WaterproofSeat is easier to stretch with Single Body, but Wrinkle does not have to enter.
Lightly paste, moderately tucker fasten and extra Seat will Cut.
Then leather Seat is covered from above and temporarily fastened.
After aligning the front and rear positions, once the Center comes out, temporarily fix and remove the center circle from the center of Seat and repeat and repeat the looseness to the outside, the front and rear positions are not misaligned If you can confirm, fold the quadrangle like a gyoza fold, fold it finely and fix it with Tucker.
I can not take a slack as I think, but carefully without impatience!
By the way, I do not use Dryer.
Because Seat becomes hard when overstretched, be careful.
Also, if you are not comfortable with work, you can cut the leather Seat with a little room.
If you can get sagging and wrinkle and carefully see that there is no Gap on Center, I will drive Tucker at 1 cm intervals.
Since the needle is easy to float in the folds, firmly push it so that the crease comes in the middle of the needle.
Finally, we finish the leather Seat which is left over with a Line of about 3 cm from Tucker.
Indeed, if you keep the basics it is something you can do neatly like a beginner like me.
* Tucker belongs to Daiso's 324 yen.
The needle has a Max's foot 6 mm.
At the fold, I hit the 8 mm thing.
It is a key product, but it is quality more than price.
Seat of Dimple machining is hard to slip and the hips no longer slide to Tank side.
this is good!
I was thinking of trying another Seat.
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА