* Это НАИЛУЧШИЙ и ДОСТУПНЫЙ ПО ЦЕНАМ магазин для приобретения японских мотозапчастей. * Зарегистрируйтесь сейчас и получите удивительные скидки и другие выгодные предложения! *Более 2,000,000 разных товаров. Невозможно НЕ НАЙТИ нужные вам запчасти и экипировку.
ВОЙТИ В WEBIKE JAPAN
Введите ваш email от 6 знаков.
Введите действительный адрес электронной почты.
Пользователь с таким email уже существует.
Ваш аккаунт заблокирован.
Указан неверный пароль и/или Email.
Нам не удалось авторизовать Ваш аккаунт через Facebook.
Требуется ваш Email, пожалуйста введите действительный адрес email.
Поздравляем! Ваш новый аккаунт создан успешно! Теперь вы можете воспользоваться особыми привилегиями для клиентов Webike и получить наиболее выгодные предложения. Если у Вас какие либо вопросы, пожалуйста, обратитесь к нам через ОБРАТНУЮ СВЯЗЬ.
Подтверждение отправлено на электронную почту, указанную Вами при регистрации аккаунта. Если письмо не получено, попробуйте связаться с нами через обратную связь.
We use cookies to provide and improve our services. By using our site, you consent to our Privacy Policy including cookie. Learn more
It is used for CB1300SF SC40 Because O-ring is set in Body, there is no need to purchase separately Anyone can install and remove Cup Type Oil Filter Wrench and TWrench As Oil drips down, it is something to receive
When I changed the oil, I also changed the filter this time. I bought PFPOil Filter like last time.
After using PFPOil Filter, I felt that it is better to change it once in 4-5000Km. This time I changed the filter at 6000Km and the oil was dirtier than the last time I changed the filter. I think the Filter is close to the limit of what it can do considering how dirty it is.
Normally, you would want to replace the Filter every time, but economically, you should replace it every other time.View Detail
I used the PFP Oil Element when I changed the oil in my CB1300 (SC40) It was
Installation is not a problem and it is comparable to OEM
I don't know how dirty the Cartridge-type Oil Element is, so I'm not sure if the Oil Element is clean or not I change the replacement every three times I don't run a lot of miles, so I change the Oil every six months, at about 6,000? Element exchange
I would use it again as it is inexpensiveView Detail
The O-ring on the Cartridge side is assembled, and the entire Body is packed with SEROW Han Film. It is not attached, please be relieved. It is assembled.. Translation (It is difficult to enter here. I buy it because it is cheap.View Detail
Actually, I do not know the good or bad of these products, no matter which one I use. So I think that cheaper is better as it is cheap. I was able to install normally, I think that after every Oil replacement, it should be replaced. In order to do that kind of thing, I think that cheaper is better as it is cheap. View Detail
I used it on my VIRAGO 250. the Large oRing could be used as a replacement part, but the Small oRing has not been used because I don't know what it is for. The quality and performance of this product is unknown as this is my first time using this product.View Detail
When I changed the oil, I also changed the filter this time. I bought PFPOil Filter like last time.
After using PFPOil Filter, I felt that it is better to change it once in 4-5000Km. This time I changed the filter at 6000Km and the oil was dirtier than the last time I changed the filter. I think the Filter is close to the limit of what it can do considering how dirty it is.
Normally, you would want to replace the Filter every time, but economically, you should replace it every other time.View Detail
Rubber's PackingSize didn't fit, but the FilterBody fit properly. Currently there are no problems. You picked the wrong part number, so you were packing the wrong thing …View Detail
Attached O-Ring is Quantity:2pc. Both sets were too thin to be useful. I think it's because of the use of other models and insufficient conformity check. The filter itself is fine.View Detail
?attachment The CBR650R is mounted at the same position angle as the NORMAL. However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away. I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose. ・NORMAL (Reserve integrated horizontal master) Impressions of No complaints on public roads. Familiar feel and very easy to handle. However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful. Radipon (Reserve separate body portrait master) Impressions of It was totally different from what I expected, my expectation was that it would feel like a Rear brake… It is really a mild and easy-to-handle radipon. On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN? But I felt the radipon effect from Breaking a little stronger, and It can be hung up to a hard brake without effort. I felt trust that this could stop.View Detail
I purchased this for use with multiple Helmets. 。 Mount included with the BOLD. Microphone and speaker are not included and must be purchased separately.View Detail
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА