This is a good products, it fits well to my Yamaha tdm850 and raised as per mentioned in the descriptions. I don\'t have to swap to a higher handlebar , just fit this on and raised the bar and now I can ride standing in bumpy road conditions comfortably.
When I installed a touring seat on my SEROW250, the handlebar position was low and cramped as expected, so I decided to purchase a bar rise kit.
Installation is easy, with only A little adjustment of the position.
Cable length is fine. Looks cool.
Ride, Position, and elbows are easy.
I wish I had purchased it earlier.View Detail
I replaced the rear shock of my KSR80 (used on another car) and customized the seat as part of the modification process. (Medium) height is now felt to be too low.
It was a hassle to replace the handlebar with a more expensive one again, so I searched around and bought this product.
Titanium or Black, 30mmUp or 19mmUp. I bought a Gun meta and a 19mmUp one.
Also, I chose this product because it is not a cap bolt fixed type, but a bolt with a flange.
The reason for this is that the bolt of the handlebar is used to fix the bracket of the added meters, and the cap bolt type does not allow them to be tightened together.
The work is quite simple:remove the NORMAL clamp and insert the bulking parts under the handlebar.
Clamp the Handlebar and you are done.
In the past, there was not much room for adjustment of the Handlebar because of interference due to the low height of the additional meters, but now the Handlebar (Clamp) is higher and the adjustment range of the Position is wider.
The height of 19mm was the right choice, as there was no sticking out of the handlebar or Cable.
I am looking forward to an easier commute and touring.View Detail
SEROW250 fe 2cm up
168cm tall
With the OEM position, the Handlebar was too low when standing, and it was difficult to maintain standing, but with the Bar rise kit, it became just right.View Detail
2007 WR250x, Y's GearHigh seat, OEM footpeg for yz125Racer, zeta comp bar, MOTARDMedium with a little change of position, our Mascene, Handlebar is a little low, so I installed zeta's Bar rise I introduced the kit, 19? As a result, the position became the ideal position as I thought, and riding became the best fun. I had a lot of doubts about the 10?Up of Akosat and the 14?Up of zeta, but I chose this one which was in stock at Webig and it was a large correct answer. I was able to get the ideal position and running. By the way, we use only the lower side of the Up riser and Bolt, and the Upper Holder is combined with the OEM parts of WR250x to make the OEM-like appearance.View Detail
I bought it because I have long arms. As a result Position became easy! I was worried about the height, but I didn't want to wear the cable pants and I thought it wouldn't make a difference. I've been using it for a while now.View Detail
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА