3,653.16 RUB
(5,980 иена)
4 (14 Отзывы)
Very Good
Handlebar Weight to prevent numbnessI bought the CB1100RS because I ditched the Weight when I went back to the OEMHandlebar from the Separate handle.
I chose this one with the Weight in the Handlebar to reduce vibration, so I chose this one with the Weight at the same time as the Bar End.
When I tried to pull out the handlebar, I couldn't get it back because the tip of the handlebar came off and remained inside the handlebar.
I pushed Rubber into the billion and put a new Weight on it.
Reviews For EFFEX Вес руля BIG для стального руля From Other Webike User
Average
Large Looking for something heavyI tried using HARDY HH 09 BK before, but it is still not effective for natural vibration.
Where I tried to change it to a heavier thing
I found this.
It is a change from 160 g to 230 g.
Attention is necessary because it is misleading with model number for 14 mm diameter.
(I came to beat the person who is nearly as small as possible)
Large in the Bar End has increased more than two times compared to the last item.
If you look at it, this Large Ki will rewind chic.
Installation is easy, but Normal handle was subtle.
What is it?
Handlebar Since the inside diameter was actually measured 18 mm, it seems that it will fit smoothly.
Included Parts : O-Ring for 18 mm as Quantity : 2pc. Set Included.
(The product has already been installed for 19 mm) ← good looking me.
I thought that it would not enter at all at all.
For 18 mm (Insert outer diameter should be smaller) Insert in place.
Well, it is still hard.
Once you pull it out and check it, some weakness on the Weight insertion side tip.
I guess it was because I put it in force.
After Slip (Not fixed and idling) It is likely to be a cause
Although I did not dare dare to paint it, I had no choice but to do it
Silicon grease applied to O-Ring.
I did not paint on the Rubber part which locks the tip collapsed.
Still it was hard, the last time I hit it a little with Praghan and inserted it.
I will pull out later Large seems to change... Is it such a thing?
After all I think that it is better to have a larger Large. (It may be your liking)
Depending on color (discoloration) I heard that the time to do is different.
Red, Blue seems to have the most influence of ultraviolet rays.
Now, how is the anti-vibration effect.
We can not ride on rainy days.
I will write it in the diary at a later date.View Detail
Most Viewed Reviews Of EFFEX Bar Ends
Excellent
Reduced handlebar vibrations! very happy with this purchase. previously i had a difficult time buying handlebar ends because they were mostly cosmetic, hardly any weight on them at all. (you need weight in order to cancel out vibrations.) and because most of this product is INSIDE the handlebar, is does not protrude too much out of the handlebar. (this is a minor cause for concern because if the motorcycle falls, the handlebar end will not have much protection. but the benefits of the vibration dampening outweight this.)View Detail
Average
EFFEX Handlebar Weight BIGข้อมูลตัวสินค้า ระบุแค่ใช้กับ Handle Bar ขนาด Outer Dia. 22.2mm แต่ไม่ได้ระบุว่าใช้กับ Inner Dia. 14 mm. ทำให้เกิดความเข้าใจผิด ไม่สามารถนำมาติดตั้งกับ Inner Dia. ขนาด 18-19 mmm. ที่มีอยู่ได้ View Detail
Excellent
It is easy to install.Installation is very easy, just tighten with Hexagonal Wrench.
I installed it on my VTR250, and the chattering feeling at the time of 1st gear acceleration was gone, and the vibration was reduced in general.
I was very pleased with the texture and it was exactly what I expected which is nice.View Detail
Excellent
This is an inexpensive product that is easy to install, but we clearly experienced the benefits.[How is it used?
Suppression of vibration transmitted to the Handlebar
Was the one you received as per Image?
Yes
Was the installation difficult?
No, sir. It generally took about 5 minutes.
How was your experience with it?
Unpleasant vibrations transmitted to the Handlebar were reduced, and hand numbness and fatigue were reduced to a large extent.
[Included Parts:were they on?
The hexagonal wrench used for installation was also included, which was convenient as there were no other tools to prepare.
[Was there anything that disappointed you?
No, there is not
Other items that would be helpful
I think that anyone can install it easily without instruction manual.
It will be installed inside the Handlebar, so there is no picture of it.View Detail
Average
Comparable to OEMI bought the Stainless Steel type when I changed the Bundle on my ST250 It's 10g heavier than the OEM, but slightly lighter than the OEM because the center of gravity is closer to the Clamp I think this is the effect In fact, there is no unpleasant vibrations up to 80km/h after installation, and it is a good thing that there is no unpleasant vibrations over 80km/h with the trunk of the knee grip There is the same cycle of vibration, in essence, the timings that vibrate are the same as the OEM The Handlebar is shorter than the OEM, so those who haven't changed the Handlebar will have to replace it and you may feel a slight increase in vibration
Other imprecise comments about the size of the O-ring:Smaller is more appropriate There was a It's a little large I installed it as it is It was not easy to fit in, and I managed to push it in with a Slotted screwdriver and a hammer However, the rigidity of the LeftGrip is clearly improved after installation, so the original performance of the LeftGrip is only press-fit It may demonstrate a
As for the ST, the OEM is a pretty heavy Bar End, so as far as vibration reduction through replacement goes It might be better not to expect too much; the Compact of the Bar End will be used to increase the vibration Enough to be an option if you are a Custom lover who wants to make Large achieve not so much I think it can be However, it is not cheap, so my honest opinion is that the cosmetic value is subtle in terms of performanceView Detail
Other Reviews From Japanese Webike user
Excellent
Radipon handled in Mild?attachment
The CBR650R is mounted at the same position angle as the NORMAL.
However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away.
I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose.
・NORMAL (Reserve integrated horizontal master) Impressions of
No complaints on public roads. Familiar feel and very easy to handle.
However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful.
Radipon (Reserve separate body portrait master) Impressions of
It was totally different from what I expected, my expectation was that it would feel like a Rear brake…
It is really a mild and easy-to-handle radipon.
On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN?
But I felt the radipon effect from Breaking a little stronger, and
It can be hung up to a hard brake without effort.
I felt trust that this could stop.View Detail
Very Good
packtalk bold Attached MountI purchased this for use with multiple Helmets. 。
Mount included with the BOLD.
Microphone and speaker are not included and must be purchased separately.View Detail
Excellent
Grip replacementGrip that had been used for a long time was worn out and had to be replaced.
They are soft and dampen vibration.View Detail
Very Good
Works well in everyday life[How is it used?
Used to lick Screw loose.
Was the one you received as per Image?
As per Image.
How was your experience with it?
When used on a strongly tightened Screw, it can be safely and securely removed.
The licked Screw was removed.
It is also useful for DIY Screw removal.
[Points to note]
When used on a licked Screw, it is best to beat it in with a Hammer before use.View Detail
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА