[Материал/материалы].
6061 Алюминий / Дельриновая смола
страна производства : Америка
Комплект ползунков переднего и заднего моста, специально разработанный для каждой модели автомобиля.
Защищает качающиеся рычаги и оси, которые легко повреждаются в случае падения..
Этот движок передней оси уникален и инновационен!.
Обычные заслонки проходят через осевой вал, поэтому каждый раз, когда вы снимаете колесо, вы должны снимать заслонки..
Но этот ползунок исключает этот шаг!
Ползунок сделан из двух частей.
Сторона вала (правая сторона, если смотреть по направлению движения) похожа на анкерный болт или конец защитной планки для рук, а при затягивании крепежного болта ползунка расширяется в валу и фиксирует ползунок..
Со стороны гайки оси сам ползунок является гайкой..
Так как ты затягиваешь гайку оси?
Эта гайка имеет квадратное отверстие 3/8", так что вы можете просто вставить в нее удлинитель или трещотку и затянуть..
Изготовлен из алюминия 6061 и смолы Дельрин с ЧПУ, обработанной спереди и сзади..
Установка ползунка задней оси - это простая замена блока прицепной оси!
*Изображение содержит другие раскраски.
*Пожалуйста, используйте запасной слайдер для SLIDE.
[Material]
6061 Aluminum/DELRIN Plastic
Country of Origin: America
Front and rear axle slider sets designed specifically for each model..
Protects swing arms and axle shafts that are vulnerable to damage in the event of a fall..
This front axle slider is unique and innovative.
The normal slider goes through the axle shaft and has to be removed every time the wheel is removed..
But this slider eliminates that one step!
The slider is made up of two pieces.
The shaft side (right side as viewed from the direction of travel) is for anchor bolts and handguard bar ends, the slider widens in the shaft when the slider mounting bolts are tightened, locking the slider in place..
On the axle nut side, the slider itself is a nut..
So how do you tighten the axle nut?
This nut has a 3/8" square hole in it for standard sockets, so you can simply insert your extension bar or ratchet to tighten it..
Manufactured from 6061 aluminum and Delrin resin, both CNC machined front and rear.
Installing the rear axle slider is just a matter of replacing the stock axle block!
*It contain other color in the photo.
*Please use the STD type for the spare slider.
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА