8,430.38 RUB
(13,800 иена)
5 (3 Отзывы)
rating breakdown
5 Stars |
|
2 |
4 Stars |
|
0 |
3 Stars |
|
0 |
2 Stars |
|
0 |
1 Stars |
|
0 |
Excellent
very good!I bought it with z2Tail of GCraft! I am also solid, making it exclusive for Balance, very good, is a recommended dish.
Reviews For G-Craft Эксклюзивные Grab Бар для Z2 Капюшона сиденья From Other Webike User
Excellent
Since it was worrisome from the time of sale, it had considered and purchased.
Since the raw material is made of aluminum, appearance is also good and a form is very also a favorite.
There was no place which it has by RIYA when the ZII tail which hSince it was worrisome from the time of sale, it had considered and purchased.
Since the raw material is made of aluminum, appearance is also good and a form is very also a favorite.
There was no place which it has by RIYA when the ZII tail which has come out from the manufacturer is attached, and it became [ since it was a car body with which it is not / free / capable of small sharp turns, ] easy when this glove bar was attached, and moving.
Moreover, since a price is very also handy, when a ZII tail is attached, it becomes an article I want you to attach simultaneously.View Detail
Most Viewed Reviews Of G-Craft Grab Bar
Very Good
Grab Bar G-CraftI was torn between the Grab Bar and the Rear Carrier, but I chose the Grab Bar for its frequency of use and appearance. I think it is a matter of taste, but since the area around the tail lamp of MONKEY is plated, I wondered whether I should match it with plating or put it together with black refreshments. As a result, the black of the frame and the texture of the grab bar were close, so I think it was a good choice. 。 I thought it would be easy to install, but I had to shift the Rear Fender a bit before I could install it. Also, there is not much clearance with the Rear blinker, so I had to work while fine-tuning. Initially, the Right Side blinker was in contact with the Rear blinker.:Pair (for Left and Right) The difference in Clearance is due to the bolt nut included in the kit. I put a black bolt nut in the opposite direction of the instruction manual because it looked bad. I will observe the progress and be careful of the Clearance. It is a long story, but you will need a tool such as Hexagonal Wrench or Glasses Wrench to install it. Be careful not to lick it, as it is hard and tight!View Detail
Very Good
CoolI'm not sure if I'd like it if it was a little taller.View Detail
Poor
A little Accent on Tail?Personally, I might be pretty unhappy with it!
I installed it on my JC92.
If you want to keep the OEM look, this is the right choice.
It is easy to install and you just need to plug it into the existing screw hole on the rail. It is very easy.
The strength of the product itself is the quintessential G-Craft. It's solid without looking like it.
However, it is unexpectedly difficult to hold because of Short Bar? If your fingers are a little thick, it is not much use because it catches in the gap between the bar and the Rear cowl.
It may be perfect for a kick rack to put your fingers on, but if you tandem for a long time, you will lose your grip.
When the Carrier is placed on the Rear Sets, it can be used as a fixed ground object.
As an overall evaluation, I can't recommend this product because its use is too limited.
If you like SMART design, this is the one for you.
It is not cost effective, so you should definitely consider carefully when buying one.
If you increase Coloring a little more, you can use it as One point, so how about improvement?View Detail
Excellent
As expected of GCraft, the construction is differentIt's been over a year since I installed it on MONKEY It's very convenient when I want to adjust the position when I'm on the road or in Garage It's quite a burden to use but there is no problem so far
Convenient, good looking, beautifully welded, no complaints, I couldn't decide between Long and Short It was just fineView Detail
Excellent
Good vibes!GCraft is solidly made.
I attached it with 31219 ShortTail Lamp Bracket and attached it, since holes for stopping the screw are the same, be careful when attaching it at the same time.
The conformity of Tail lamp for 4L was nice feeling without complaintView Detail
Other Reviews From Japan User(translated)
Excellent
Radipon handled in Mild?attachment
The CBR650R is mounted at the same position angle as the NORMAL.
However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away.
I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose.
・NORMAL (Reserve integrated horizontal master) Impressions of
No complaints on public roads. Familiar feel and very easy to handle.
However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful.
Radipon (Reserve separate body portrait master) Impressions of
It was totally different from what I expected, my expectation was that it would feel like a Rear brake…
It is really a mild and easy-to-handle radipon.
On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN?
But I felt the radipon effect from Breaking a little stronger, and
It can be hung up to a hard brake without effort.
I felt trust that this could stop.View Detail
Very Good
packtalk bold Attached MountI purchased this for use with multiple Helmets. 。
Mount included with the BOLD.
Microphone and speaker are not included and must be purchased separately.View Detail
Excellent
Grip replacementGrip that had been used for a long time was worn out and had to be replaced.
They are soft and dampen vibration.View Detail
Very Good
Works well in everyday life[How is it used?
Used to lick Screw loose.
Was the one you received as per Image?
As per Image.
How was your experience with it?
When used on a strongly tightened Screw, it can be safely and securely removed.
The licked Screw was removed.
It is also useful for DIY Screw removal.
[Points to note]
When used on a licked Screw, it is best to beat it in with a Hammer before use.View Detail
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА