- Подходит для:
- KAWASAKI Z800 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI 750SS Mach IV (H2) 71-
There is no snagging, etc., and it works normally.I think that the quality of the bearing depends on the degree of low wear. I think it can be used without any problem as long as it rotates well and d...Прочитайте больше - Подходит для:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
You can taste the effect, but be careful because Tandem is deprecated!I feel like I can tandem it, since it doesn't seem to lack strength from what I can see, but…It would be nice to be able to taste ...Прочитайте больше - Подходит для:
- KAWASAKI Z2 (Z750RS) 72-78
- KAWASAKI Z1100 *except LTD and Spectre 80-86
- KAWASAKI Z1000 77-86 All years
- KAWASAKI Z1 (Z900) 73-76
- KAWASAKI Z 750 L4 85-87
- ...и более.
I replaced a 40-year-old normal suspension and it worked great.On the KZ, I removed the tail cowl and iron fender, placed the for vehicle jack between the frame and tire, and lifted up the body to rep...Прочитайте больше - Подходит для:
- KAWASAKI Z1000MKII 79-80
- KAWASAKI Z1R-II 79-80
- KAWASAKI Z1R 78
- KAWASAKI KZ1000 77-78 (Round tank)
- KAWASAKI KZ900 76
I just don't know when.Cancellation.Прочитайте больше - Подходит для:
- KAWASAKI KZ1000 Z1
- KAWASAKI KZ1000 Z1-R
It is for not knowing when it will be, so I will Cancel.Прочитайте больше - Подходит для:
- KAWASAKI KZ1000 Z1-R
- KAWASAKI KZ1000 Z1
I'm not sure when I'll be able to cancel.Прочитайте больше - Подходит для:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z1000
- KAWASAKI Z1000 MkII
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z750FX
- ...и более.
I bought this product because OEM Parts was discontinued.This is a small part, but without it, you cannot fix the Light Bracket.I am grateful that Ripro has released these Parts.Прочитайте больше - Подходит для:
- KAWASAKI Z2 (Z750RS) 72-78
- KAWASAKI Z1100 *except LTD and Spectre 80-86
- KAWASAKI Z1000 77-86 All years
- KAWASAKI Z1 (Z900) 73-76
- KAWASAKI Z 750 L4 85-87
- ...и более.
Very good product.It looks great and I like it.Прочитайте больше - Подходит для:
- KAWASAKI Z1100R 81-84
- KAWASAKI Z1100GP 81-84
- KAWASAKI Z1000 (air-cooled) 81-84
- KAWASAKI Z1100R 81-84
- KAWASAKI Z1100GP 81-84
- ...и более.
I changed the Swing Arm to Other Brand Product the other day, so I installed the Guide roller to avoid interference with the Chain.The shop where I installed this car said that the installation accura...Прочитайте больше - Подходит для:
- KAWASAKI Z2 (Z750RS) 72-78
- KAWASAKI Z1100 *except LTD and Spectre 80-86
- KAWASAKI Z1000 77-86 All years
- KAWASAKI Z1 (Z900) 73-76
- KAWASAKI Z 750 L4 85-87
- ...и более.
I had been using the OEM Ripro for about a month when I bought it new, and it felt like it was a no-suspension ride and was going to break my body, so I installed the Icon Suspension and the performan...Прочитайте больше - Подходит для:
- KAWASAKI Z1100GP [Application] Pivot shaft
- KAWASAKI Z1000R [Application] Pivot shaft
- KAWASAKI Z1000J [Application] Pivot shaft
- KAWASAKI Z1100R [Application] Pivot shaft
- KAWASAKI Z1 (900SUPER4) [Application] Pivot shaft
- ...и более.
I'm using it on my Kawasaki KZ1000JJB's Chromoly hollow shaft was first attached to the rear axleI love it because I can now use JTrip's STAND and I like the finishThis kind of parts are inevitably go...Прочитайте больше - Подходит для:
- KAWASAKI Z1 (900SUPER4) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- ...и более.
I changed it for the sake of appearance The attached Master Cylinder cannot be installed unless it is processed It is possible to process a little bracket with FileПрочитайте больше - Подходит для:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
Exhaust BracketCut or Exhaust BracketCut to fit the NORMAL Swing Arm You need to replace the rear suspension with a shorter one I replaced it with SEA BASS 320? suspension and installed itПрочитайте больше - Подходит для:
- KAWASAKI
- KAWASAKI Z1000 (A1-A4)
- KAWASAKI Z750-D1 (KZ750D) 77-80
- KAWASAKI Z750FX -1
- KAWASAKI Z1-R/Z1-RII
- ...и более.
For dust protection and water proofing, non-contact rubber seal type bearing is used I don't think it doesn't matter much if you have a seal or not Collar will be installedIf this Seal is stupid, it w...Прочитайте больше - Подходит для:
- KAWASAKI Z1000 (air-cooled) 76-80
- KAWASAKI Z1000 (air-cooled) 76-80
The finish is remarkable, unless you don't like the three-part Axle Shaft construction Mast bye ItemsIt may be necessary to change the diameter of Axle Shaft depending on the spec. of the wheels and f...Прочитайте больше - Подходит для:
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1100R
- KAWASAKI Z1100GP
- ...и более.
By replacing the old chain slider with one made by PMC, the smallness of the chain slider was reduced to the MK2 The parts are new and the footing is tighter and I am satisfied with the productПрочитайте больше - Подходит для:
- KAWASAKI Z750FX
- KAWASAKI Z1000 MkII
- KAWASAKI Z900 (KZ900) 76-80
- KAWASAKI Z750 (air-cooled) 76-80
- KAWASAKI
- ...и более.
I installed it in my Kawasaki Z seriesIt was discount time, so I was able to purchase it at a fairly low priceThere are two color choices, and the design is good for Parenthesis and Cost Performance i...Прочитайте больше - Подходит для:
- KAWASAKI Z750FX
- KAWASAKI Z1000 MkII
- KAWASAKI Z900 (KZ900) 76-80
- KAWASAKI Z750 (air-cooled) 76-80
- KAWASAKI Z1000 (air-cooled) 76-80
- ...и более.
I installed it in my Kawasaki Z seriesIt was discount time, so I was able to purchase it at a fairly low priceThere are two color choices, and the design is good for Parenthesis and Cost Performance i...Прочитайте больше - Подходит для:
- KAWASAKI Z1000 72-80
- KAWASAKI Z750-1000 72-80
- KAWASAKI Z750 72-80
About half the price of OHLINS. design is similar But I bought it because it has a pretty good reputation on the streetReplaced from the then-Offset Connie The Connie has only 3 levels of spring pre-r...Прочитайте больше - Подходит для:
- KAWASAKI
- KAWASAKI
- KAWASAKI Z1-R/Z1-RII type I (blood
- influenza
- hepatitis
- ...и более.
When installing, it is a difficulty to not attach unless Frame is processed first.Since MORIWAKI's Monaca Exhaust System also does not have this Rear Sets, we will use the MORIWAKIBean-jam-filled ...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА