HONDA SUPER CUB 50 (C50)

I think it's going to get good mileage. It's going to make the engine run better.

[How is it used?
Monkey Type Z Full Kit 88cc Type S Cylinder of MINIMOTO (https://www.webike.net/sd/23872950/) I installed it at the same time when I installed here.
Before that, I had a 75...

My headlight started to flicker after 2 yrs then my friend recommended me this Takegawa hyper ignition coil. After installing it, i noticed there is some improvement. Starting up is also good.

I used it on my Z125pro!
I'm not sure how well it works, especially since I haven't done any Bore up or other mods, but I bought it in a Custom mood!
Installation was easy

The NORMAL is soft and comfortable to ride, but it feels a bit wobbly and scary at a high pace, so I changed it. Thanks to the tightened suspension, the sense of stability increased and it became...

I bought these to convert my lights to LED. I am satisfied with the sharpness of the light.

First of all, I checked the Jet before installation and found that both Throw and Main had shiningly shavings. If you use it without checking, it will be clogged. If you use it without checking, ...

I used it on a CUB50 revision 75.
If you have a normal clutch, it will slip, so it's better to do it to properly transfer the Up power to the drivetrain.
By the way, I install it myself, so...

It's a normal 1998 50cc SUPER CUB with 40,000km running and the clutch is the limit. Gaskets are also included. The acceleration is perfect and I can run without stress. I don't know how long it ...

I installed the Mukawa Oil cooler on my SUPER CUB. For long touring in summer, 0.7? Long touring of long distance is also safe because of severe deterioration in Oil.
I want to go to Shimanami...

I have installed it in the front and back of JAZZ. The installation was a breeze. They have been in place for about 6 months since I installed them. The more you grip it the more it works. I don'...

Покупал на хонду апе. Старые подножки были и трепать. Эти подножки ничем не отличаются от оригинальных хондовских, но стоят дешевле, поэтому я их и купил на свою хонду аре. Считаю что оригинальны...

With OEM Parts, eh? There are times when it's surprisingly expensive, but this one is not.
I've often said that OEM and OEM products are the same etc., and I don't think you'd be able to tell ...

NTB's Air Filter has bought a variety of vehicles in the past, but this one felt like the best fit.
If the exchange Cycle is quicker, it's not as fast as the OEM, but it's also more Engine fri...

I don't feel that this product is any better because of it.
However, there is no lack of practicality.
They do the job we want them to do without any leaks.
Necessary and sufficient

When replacing the Exhaust System, I replaced the old gasket.
The old Gasket was sticking, and after applying carburetor cleaner, I tapped a slotted screwdriver with a plastic hammer and stuck...

It is cheaper than OEM parts and the quality is the same as OEM parts
When the exhaust system and engine are removed or installed along with the all-pen work, the exhaust system and the engine...

I bought this because my Normal cabAir cleaner was dirty! You won't feel the difference as much as you will after you replace it, but it's a nice feeling to install a new one Right!

I don't think bagging is … even though it's a LENS thing first!
When you open it up, you see that one of the license plate lights is missing
I'm very sorry

Заказал данный фильтр 15.01.20 самой дешёвой доставкой без отслеживания, пришла посылка 28.03.20. На мопед пока не ставил, эта моя первая покупка на вебайке решил попробовать и результатом доволе...

To replace all the Knock Pins when installing the Bore Up Kit into the DAX.
Purchased
I don't have a Parts List, so it was a hassle to find out the OEMParts No.
I chose this product beca...

Installed on a JC75 Grom. the key box area was plain, but it was tightened up a little with Red One point. It's easy to dress-up with Double-sided tape to match the original display. It's cheap, ...

Used for Bore up of SUPER CUB 50.
In general, 88cc is the usual way to bore up from 50, 75cc is not enough.
Nice thing
? It's above the waist, so you can assemble it by yourself. Don't w...

Item was initially ordered for GROM but used on a CRF250Rally anyway. Colour RED. Quality is fantastic. Fitment is perfect. Installation work is easy. Highly recommended item.

Break-in done, no problems.
I switched to high octane fuel and my mileage per liter increased by about 10km.
I'm satisfied!

I'm a hobbyist, but I've been playing with CUBEngine for about 20 years.
It's easy to lose the CUB transversely installed engine above the waist like a plastic model.
Take it slow, it takes...

Quantity:2pc. This is the second set purchased
Last time it was CHALY and this time it's Dax.
Used.
I've installed it once before.
It went on Smooth.
TorqueUP and it feels good. Прочитайте больше

Quantity:2pc. This is the second set purchased
The vehicle that was last bored up.
Clutch slips when he kicks
I replaced it because it was there.
This time, the Bore up vehicle is aga...

The OEMNORMAL product has been stripped off with age, so I replaced it.

I replaced the old one, so it's no surprise, but it's a much better and safer ride with much better efficacy and tou...

I purchased and used it in SUPER CUB110 (JA44) to make a 420 conversion of the chain size.

I've been able to wear it with no problems and have no worries.
I'm happy with the durability ...