HONDA MONKEY Рамы / Защита

It looks good but was difficult to install.

I had these on my honda monkey minitrail. Very handy for lubricating your chain or removing your wheel. I am definitely going to buy these again for my other z50j6

The first thing that is not allowed to be installed is the vehicle body with the ReDeer Stand Hook (installed under the suspension) and the OVER Swing Arm.
The length of KITACO's Axle Shaft wa...

I installed it on Axle Shaft.
I like the look of it, it's beautiful.

The main purpose of the Stand Hook is to prevent the Bolt from being damaged in a fall, but I use the Stand Hook here.

When I fell over, it tore off and flew off, leaving the part that was tightened up by the Bolt. The part that was torn off was not damaged so much, and I think that it flew away before it did not...

I attached it to NORMAL's 12 V MONKEY.
Maintenance became easier, such as Chain adjustment.
However, adjustment of flip angle is troublesome.
In my case, the Stand Assist bar was in ...

I bought it for Seat installation made by SHIFT UP.
Because I was aiming for the OEM style finish, if possible, I wanted the size of Hexagon Bolt, Nut's head to be 14 instead of 17, and Un...

I used Axle Slider as a Rear suspension slider.
Since it is not overturned after installation, the effect can not be said anything, but it seems quite possible to expect.
Those who are inst...

I installed it next to maintenance.
I bought Silver, but making is also polite and smart than I imagined.
In order to install Axle Shaft you need tools such as Deep socket so you need to pr...