HONDA MONKEY R

Good product. You will be very satisfied with it because it is expensive.
This product is a head kit that can be used to version up from SSTage to RStage.
It is wonderful that I can work wi...

When customizing the undercarriage, the OEM parts looked kind of shabby, so I used Point to buy them. It's not a noticeable part, but I'm still happy with it as one point when replaced.
It's n...

Feel happy with that thing. Make my engine bright and focus eyes. Recommend to buy that head cover for decoration and its low press air function

I couldn't use the Crankcase of my car because it had an arched part where the Crank Shaft Bearing is inserted.

I used it for my CB50S Restore.
I chose this inexpensive product.
At the same time, the chain is exchanged.
I couldn't compare it to the OEM condition because I didn't drive it, but it w...

[Was there anything that disappointed you?
None in particular

Do you have any wishes or improvements you would like to make for the Manufacturer?

[Do you have any products to com...

Used in MONKEY 75cc
I tried Rose because the engine was not well and the noise came out, then I tried Camshaft Chain and The Camshaft Sprocket was running low, so I had to replace it with a ne...

The Head Lover on the Cam Chain Tensioner Push Rod for over 30 years is getting dented has always bothered me This is the solution to the dents It's a very beautiful product at the same time and ...

Easy to install and up the fashion quotient
It's good to be able to tweak the details a little bit, isn't it?
Two Quantity:It's a set, so that was good too

I used to wear the aluminum type ones, but Anodized faded and The part that contacts with the brake arm was worn out and blacked out I chose the Stainless Steel Type

The quality is as good as a domestic manufacturer's, so there is nothing to worry about.
I'm waiting for it to grow a little bit during break-in, but I can't see any progression in growth from...

I bought it expecting Long life from Non-seal Chain.

I haven't been able to check it too much after installation because the Chain area is a full cover Cub Pro, but it still looks fine aft...

I installed it on my Yamaha YB50. I was a novice at installing it myself, but even with the instruction manual I was able to understand how to install it.
The product itself was massive and vi...

After one run of Muddy, the color plating came off and the Roller had rust on the mudflats Company R and Company D don't seem to like it
I will never buy again

항상 ek 사용했는데 이번에는 좀 좋은 제품으로 골라봤습니다 이 제품이 420 중에 제일 상급 모델로 알고 있는데 맞나 모르겠네요 혼다 msx125에 사용하려고 106링크 구매했습니다 아직 교체는 안했지만 좋은제품이니 잘쓸수 있겠죠 I always used ek This time I chose a good product T...

EK chain with o ring is one of the best chain for my honda dax motorcycle 125cc engine. You may have to cut it before using it on some bikes, which may require additional equipment.

Used in LITTLE CUB (AA01)

It is packaged in a very viscous Grease application, which may be specific to EK It was
There was some resistance to using it as it was, so after cleaning it w...

Connecting like couldn't be assembled. I tried to install the connecting clip but I failed. I removed the connecting link from the chain, and I found that joint plate's hole is smaller than the ...

EK CHAIN HEAVY DUTY 420SR ( NUMBER OF LINK 110 ) The chain can really fit to my GPX Demon very well. Like the color of the chain so much, and I felt more silent compare with my original chain. I...

I am using it for MAGNA 50.
Replaceable with Clip type without special tools.
There is no problem in quality, and if you are a non-seal original, you can use it for a long period with regul...

The TSUKIGI Rear Sets Brake pedal on the NINJA
Rubber is out, so I bought and installed it as for Repair.

On exchange, follow the same procedure as for the Handlebar Grip.
Fully hang...

We purchased it because it can be used for over Rear Sets at Impre of others. It is perfect. ZrX1200DAEG and APE 100, both over Rear Sets, but it worked properly. I will purchase it again if it r...

As shown in the picture, it was carefully packaged as Gcraf's Parts. Manufacturer's Manufacturer was written on the Reverse side of this bag and I was deeply moved because it was a famous...

I am attaching to Normal wheel.
It looks like finish and looks like GCraft,
It is very beautiful.
Installation precision is perfect, there is no such thing as complaint.

The feeli...

If parts are replaced to the Back step of an external article with much trouble, the new Rubber of the decrease of a pickpocket is smarter than the Change pedal rubber of a vine vine.Since the Прочитайте больше

A way obtains the Rubber of a used Back step only by changing, since it is only what has deteriorated!

[Webike Monitor] It attached to
2010 model Z1000. Although I thought that the Rubber of the
Change pedal had a peculiarity of how to ride, since it was wearing out, it exchanged drastical...

G craft It has purchased and equipped with the back step for monkey R.
although position change could be performed if it is a frame of normal.
The frame of the graft G16 has various restr...

All are DEKAI! A step, a shift, brake -- After cutting all and shortening, the admiration which sticks out horizontally too far does not resign. -- It is w which it can seldom be complained since...