JETECH TOOL Гнездо СК3/8-12 3/8 (Шестигранник)
Jay TEC of cheapness (lol)It can be used with no problem.The Main tool I use is a KTC, but I bought it because it was cheap.It's not a cheap or bad thing.
 |  |  |
| | | |
 |  |  |
| | | |
 | ||
| |
JETECH TOOL Инструмент КПК-65 дисковый поршень тор...
When I inserted it into the Caliper of the two-wheeler, it went in to the tip, but not the whole surface. (There are pictures.)I turned the Handlebar from there, but it takes a lot of force.It was dif...
JETECH TOOL Датчик толщины (23пк.9
I bought it for Point and Tappet maintenance.The 0.02mm was crumpled. It seems to be able to stand up to use somehow, but I wondered if this was a bad idea, even though it is a cheap one.The oil-cover...
JETECH TOOL Инструмент КПК-65 дисковый поршень тор...
The Brake Caliper Pistons are easily pushed back in to replace the Brake Pads, which is less scratchy and more efficient than using Pliers to replace them.
JETECH TOOL Потоки 11-13 ключ
I bought this one as an extra because I wasn't sure I could rely on the on-board tool. I usually use the KTC, but it's a little inferior to the Home Center tools, and it's a lot more accurate and soli...
JETECH TOOL Толщиномер (32шт.)
I bought it to adjust the Valve clearance on my ELIMINATOR 250The EX250 Engine, which is also used in the current NINJA and VERSYS, is a mature engine After 60,000km, it started to make a nasty noise ...
JETECH TOOL Инструмент КПК-65 дисковый поршень тор...
I've been using products with a single-core shaft guideThe structure is severely twisted, limiting its useI think this product is good for GJ in that regard
JETECH TOOL Датчик толщины (23пк.9
I bought it to adjust the Tappet of GromWhen I opened it, it was slimy with oil?I could use it without any problem, but the screw of the shaft was loose and it was going to be RoseRose You have to be ...
? 
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА