- [How is it used? CarburetorMaintenanceWas the one you received as per Image? Almost as per ImageHow was your experience with it? Easy to use[Points to note] The thinnest Wire is the easiest to habitua...Прочитайте больше
- [How is it used?The two deepest of the four shots can also be easily adjusted.After closing off the screws, I put them back in, and since there was no memory, I made my own.Was the one you received as...Прочитайте больше
- I used to use hard copper wire to clean the holes in my jets and carburetors, but with this product, the material is very stiff and easy to handle. This product is very easy to use because of the stif...Прочитайте больше
- I used it for the Slow Jet route.As the destination is like File? So lubricate oil to prevent scratchingI used it.In my case the path is packed with things like O - ring fragments?I was able to take o...Прочитайте больше
- Although an end part may be notched and it may be good for cleaning up, is a hole extended if it uses too much?
Using a thin wire and 1000-sheet through now also by will be lost.
Прочитайте больше - "It was found while looking for the suitable tool to clean the jet of a carburetor, and I purchased immediately. Although a suitable wire etc. were used before using this, but thickness did not suit, ...Прочитайте больше
САМЫЙ БОЛЬШОЙ
МАГАЗИН В ЯПОНИИ
РАСПРОДАЖИ,
АКЦИИ, СКИДКИ
БЫСТРАЯ
ДОСТАВКА