Кронштейны тормозных суппортов от бренда G-Craft для мотоцикла: купить с доставкой из Японии

G-Craft Поддержка суппорта

The price and the texture are both Large It is the affinity of the hole of Rotor and the angle of hit of Brake Pads etc When I apply the brake, I hear a tsk tsk sound I wondered if there was a problem in my installation, but I found the same problem in the blog of a certain shop That's what it seems...

Прочитайте больше

Подробности Товара

G-Craft Поддержка суппорт для Brembo 2P суппорту

We used it for our 12-inches GORILLAI'm using a 220mm NSR50 OEMRotor, but I'm running it at low speeds and I'm not going to be able to get the Brake When it's not being run "hang, hang, hang, hang When you brake, the sound stopsThe sound didn't stop even after making sure there was no installation m...

Прочитайте больше

Подробности Товара

G-Craft Краб Брембо поддержки суппорта

Satisfied because bremboPad comes to the same position as NORMALPadInstallation of SUS Bolt comes with. Bolt attached to Front fork has Lock tite, Caliper side attached with Thread compound attached.

Прочитайте больше

Подробности Товара

G-Craft поддержка Задний суппорт

I use it on STD Disc, but I was hit by Normal caliper 1 / There is a feeling of strangeness appearance because Pad only hits about 3. You had better lower it a little more..

Прочитайте больше

Подробности Товара

G-Craft Краб Брембо поддержки суппорта

Especially it can be used without problems, but the attached Bolt is looking emphatically or the diameter of the bearing surface is small Small anxiety.Although it may be individual differences, because the Caliper Center is Gap, I am adjusting the Shim and using it.

Прочитайте больше

Подробности Товара

G-Craft Поддержка суппорта Brembo 4P

I am unsatisfied with the embossed 1 pot of Z125pro so I replaced it for brembo 4 pot before delivering a new car. In that case, I chose this product. I bought it without worrying about some Cost because of the security of Brand whether there was any other company's choice.There is nothing to sa...

Прочитайте больше

Подробности Товара

G-Craft Краб Брембо поддержки суппорта

I bought it for inserting Crab type Brembo caliper into Z125PRO.As Caliper support, the accuracy is good, and the Taper bolt attached to the Caliper side can also be good Parenthesis.The overall design Balance is also nice.

Прочитайте больше

Подробности Товара

G-Craft Радиальная Монтаж суппорт Поддержка GROM

* See the rust area of the brake disc, where the former brake calipers seated full.
* The new bracket do not allow that and left 6-7mm untouch!!!

Прочитайте больше

Подробности Товара

G-Craft Радиальная Монтаж суппорт Поддержка GROM

*machining and material are very good.
*but the bracket do not allow the brake pads to cover fully, left 6.5mm of pads material non contacting the brake disc - very bad!!!
*it is make for a 334-335mm disc?! and not the 220mm factory size.
*offset of the brake need to put 2mm shims to center the c...

Прочитайте больше

Подробности Товара